Hikvision DS-3E1510P-SI 8 Port Gigabit Smart POE Switch with 2 Gigabit Fiber Optical Ports

-8 × gigabit PoE ports, and 2 × gigabit fiber optical ports.

-IEEE 802.3at/af standard for PoE ports.

-Network topology management, alarm push, network health monitor.

-6 KV surge protection for PoE ports.

-AF/AT camera can reach up to 300 m in extend mode.

-PoE watchdog to auto detect and restart the cameras that do not respond.

-Various layer 2 management protocols such as STP/RSTP, VLAN, link aggregation, SNMP, QoS and so on.

General Shell Metal material Net Weight 1.21 kg (2.67 lb) Gross Weight 1.3 kg (2.87 lb) Dimensions (W × H × D) 217.60 mm × 27.80 mm × 108.55 mm (8.57'' × 1.09'' × 4.27'') Operating Temperature 0 °C to 40 °C (32 °F to 104 °F) Storage Temperature -40 °C to 85 °C (-40 °F to 185 °F) Operating Humidity 5% to 95% (no condensation) Relative Humidity 5% to 95% (no condensation) Power Supply 48 VDC, 2.5 A Installation Mode Desk-Mounted,Wall-Mounted Max. Power Consumption 120 W Power Consumption in Idle 7 W Surge Protection 6 KV Network Parameters Ports 8 × Gigabit PoE port,2 × Gigabit fiber optical port MAC Address Table 8 K Switching Capacity 20 Gbps Packet Forwarding Rate 14.88 Mpps Internal Cache 4.1 Mbits PoE Power Supply PoE Standard IEEE 802.3af,IEEE 802.3at PoE Power Pin End-span: 1/2(+), 3/6(-); PoE Port PoE: Ports 1 to 8 Max. Port Power 30 W PoE Power Budget 110 W Software Function Long Range

Ports 1 to 8: up to 300 m.

Long range performance may vary depend on camera model or cable condition.

Port Isolation

Ports 1 to 8: port isolation mode to improve network security.

Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.

PoE Watchdog Ports 1 to 8: auto detect and restart the cameras that do not respond. Link Aggregation

Link aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection.

Support static link aggregation.

Support 8 aggregation groups.

Loop Prevention

Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default.

Support 802.1D STP.

QoS

QoS is used to allocate bandwidth to different services so as to provide end-to-end service quality assurance.

Support port-based priority configuration.

Support SP, WRR priority schedule mode.

VLAN

VLAN is used for network scale planning and network health improvement.

Support 802.1Q.

Configurable VLAN ID from 1-4094.

Support Trunk, Access port mode.

Support Max. 4094 VLAN.

HPP

Support one-click activation and remote management via Hik-Partner Pro. Functions supported:

1. Display the port rate.

2. Display the port bandwidth utilization rate.

3. Display the PoE power usage.

4. Display topology information.

5. Display the alarm status.

6. Restart ports and devices.

7. Enable port long-rage mode.

8. Remotely upgrade the device.

System Maintenance Remote upgrade, default parameters recovery